Hard Disk Failure Error Codes:
If you are experiencing any of the following errors then you may need
the Data
Recovery Lab services.
Hard Drive/IDE Errors:
1701 1702 1703 1704 1705 1706 1707 1708 1709
1710 1711 1712 1713 1714 1715 1716 1717 1718
1720 1726 1730 1731 1732 1733 1735 1736 1737
1738 1739 1740 1750 1751 1752 1753 1754 1755
1756 1757 1780 1781 1782 1790 1791 Fixed disk general POST error;
Drive/controller time-out error Drive seek error;
Controller failed Drive sector not found error;
Write fault error Drive track O error Head select error;
Error Correction Code (ECC) error Sector buffer overrun;
Bad address mark Internal controller diagnostics failure;
Data compare error Drive not ready Track O indicator failure Diagnostics
cylinder errors;
Surface read errors Hard drive type error Bad diagnostics cylinder Data compare
error;
Controller error BIOS undefined error return Bad command error Data corrected
error;
Bad track error Bad sector error Bad initialization error Bad sense error Drive
verify failure Drive read failure;
Drive write failure Drive random read test failure Drive seek test failure
Controller failure Controller Error;
ESDI Drive and Controller Error Codes:
10450 10451 10452 10453 10454 10455 10456 10461 10462 10463 10464
10465 10466 10467 10468 10469 10470 10471 10472 10473 10480 10481
10482 10483 10484 10485 10486 10487 10488 10489 10490 10491 10499 Read/write
test failed;
Read verify test failed Seek test failed Wrong device type indicated Controller
test failed sector buffer test;
Controller failure Controller diagnostic command failure Drive format error
Controller head select error;
Drive read/write sector error Drive primary defect map unreadable Controller;
Error Correction Code; (ECC) 8-bit error Controller; Error Correction Code (ECC)
9-bit error Drive soft seek error Drive hard seek error; Drive soft seek error
count exceeded; Controller attachment diagnostic error; Controller wrap mode
interface error Controller wrap mode drive select error Read verify test errors
Seek failure; drive O Seek failure; drive 1 Controller transfer acknowledge
error; Controller reset failure;
Controller; head select 3 error Controller; head select 2 error Controller; head
select 1 error Controller; head select O error;
SCSI Drive and Host Adapter Error Codes:
096xxxx
112xxxx
113xxxx
210xxxx SCSI adapter with cache (32-bit) errors
SCSI adapter (16-bit without cache) errors
System board SCSI adapter (16-bit) errors
SCSI fixed disk errors
|
